Isotherm Imaging

Home / FAQ

Frequently asked questions

If your question is not here, send it over and you will get an answer within one business day.

Electrical scans

Do you need to shut down the equipment?
No. The scan has to be done while equipment is running, because problems only heat up under load. Ideally circuits are carrying at least 40 percent of their normal load. If a building is lightly loaded, we will suggest a better time to scan.
Who opens the panels?
A qualified electrician, usually your own contractor, removes covers and opens enclosures. Isotherm Imaging scans from a safe distance and never touches energized equipment.
Do you make repairs?
No. We find and document problems; your electrician quotes and completes the repairs. That keeps the report independent and keeps the repair work with the contractor you already trust.
How often should equipment be scanned?
NFPA 70B, the standard for electrical equipment maintenance, calls for infrared inspection of most electrical equipment at least once a year. Some insurers ask for it as well. Critical equipment may warrant more frequent scans.
How long does a scan take?
A small commercial building with a handful of panels usually takes two to four hours on site. Larger facilities are quoted by the number of panels and pieces of switchgear.

Buildings, roofs and solar

When can heat-loss surveys be done?
In cold weather, when it is at least about 18°F colder outside than inside, and ideally overnight or early morning without direct sun on the walls. In New England that means roughly November through March.
When can roof moisture surveys be done?
In the evening after a clear, sunny, dry day, with a dry roof surface and light wind. Spring through fall works best. The survey is scheduled around the forecast.
What size solar arrays do you inspect?
Rooftop commercial systems through ground-mounted arrays of several megawatts. Solar thermography needs strong, steady sunlight, so flights are scheduled for clear days from spring through early fall.

Drone flights

Can you fly in downtown Boston or near airports?
Yes, where the FAA allows it. Much of Boston sits in controlled airspace around Logan Airport, so flights are planned with FAA airspace authorization where required, along with any permission needed from the property owner.
Do you need anything from us before a flight?
Permission to fly over the property, a contact on site, and any site safety requirements. For facades and structures, the scope and image naming your engineer wants.

Reports, pricing and paperwork

How soon do we get the report?
Within three business days of the scan. Priority 1 findings are reported to you on site the same day, before the written report.
Can the report carry our company name?
Yes. Electrical contractors and engineering firms can have reports prepared under their own name for their clients.
How is pricing set?
Every job gets a fixed quote based on scope: the number of panels for electrical scans, building size for heat-loss surveys, square footage for roofs, megawatts for solar, and the number of elevations or elements for facades and structures. Annual agreements and multi-building portfolios are priced lower.
Are you insured?
General liability and professional (errors and omissions) insurance are in place before the first job, and drone liability insurance before the first drone job. Certificates of insurance are available on request, with your firm named as additional insured if needed.
What area do you cover?
Within about 70 miles of Boston: greater Boston, MetroWest, Worcester, the North and South Shores, Providence and southern New Hampshire. Sites further out can be quoted with a travel charge.